ECS ATA 100 945GCT-M2 DRIVER DOWNLOAD

Click Next run the Installation Wizard. Follow these instructions to install an add-on card: Connecting Case Components Connecting Case Components After you have installed the motherboard into a case, you can begin connecting the motherboard components. Connecting Case Components After you have installed the motherboard into a case, you can begin connecting the motherboard components. Any changes can affect the operation of your computer. Page 12 Memo Introducing the Motherboard Installing Hardware Installing the Processor Caution:

Uploader: Kigarn
Date Added: 24 December 2008
File Size: 50.20 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 7540
Price: Free* [*Free Regsitration Required]

ECS GCT-M Specs – CNET

Do not over-tighten the screws eccs this can stress the motherboard. If the clip of the cooling fan scrapes across ecs ata 100 945gct-m2 motherboard, you may cause serious damage to the motherboard or its components. Refer to the table below for information: Page 21 Table B: Attach the other cable end to the SATA hard drive. Setup Tab Setup Click the Setup button to run the software installation program.

New BIOS provides support for new peripherals, improve- ments ecs ata 100 945gct-m2 performance, or fixes for known bugs. Page 12 Memo Introducing the Motherboard Integrated Peripherals This page sets up some dcs for peripheral devices connected to the system.

Recent Drivers  DRIVERS: HP LASERJET M1530 MFP SERIES

Refer to the following: Check the box next to the items you want to install.

ECS > GCT-M2/ (VA)

By pressing ‘print’ button you will print only current page. Create a bootable system disk. Shutdown Temperature Disabled Enable you to set the maximum temperature the system can reach before powering down.

Operation is subject to the following conditions: Integrated Peripherals Integrated Peripherals This ara sets up some parameters for peripheral devices connected to ara system. You set this value to No to free ecs ata 100 945gct-m2 an IRQ. It elimi- nates limitations of the ecs ata 100 945gct-m2 Parallel ATA interface.

Checking Jumper Settings This section explains how to set jumpers for correct configuration of the motherboard. Connect the standard power supply connector to ATX1. Select from the menu which software you want to install. Follow these instructions to install an add-on card: Install new BIOS as follows: If not, Not Installed displays.

Connecting Case Components Connecting Case Components After you have installed the motherboard into a case, you can begin connecting the motherboard components.

Recent Drivers  DRIVER: GEFORCE 9400 GT 1GB DDR2

Got it, continue to print. Attach either cable end to the connector on the motherboard. Below you can find a brief description of each software program, and the wta for your motherboard version.

Expansion Slots Expansion Slots Installing Add-on Cards The slots on this motherboard are designed to hold ecs ata 100 945gct-m2 cards and connect them to the system bus.

To print the manual completely, please, download it. An item installation screen appears: Remove a blanking plate from the system case corresponding to the slot you are going to use.

ECS 945GCT-M2/1333 Manual

Use this item to do wake-up action if inserting the PCI card. Page 6 Integrated Peripherals Advanced Chipset Ecx This page sets up more advanced information about your system. Enter text from picture: